Arbin 发布
How to perform DC Internal Resistance measurement with Arbin?
Mechanism explanations: Arbin’s MITS software uses pulse method to calculate IR. In order to achieve better accuracy, the software measure the IR 10 times and take the average. The pulse looks like the graph bellows: IIR is the amplitude value T2 is the Extra Control value1 I0 is the offset value IR Calculation Formula: IR […]
阅读更多
Enhancing Battery Testing Safety with a Door Switch Interlock System
I. Purpose and Applicability Battery testing—whether for electric vehicles, consumer electronics, or industrial systems—demands strict safety protocols. One often overlooked but critical element in test chamber safety is the door switch interlock system. This simple yet powerful mechanism helps prevent injuries, equipment damage, and test data corruption. In this article, we’ll explore how door switch […]
阅读更多
如何使用 Arbin 根据 IEC 61960 执行内部电阻测量？
红外测量对于深入了解电池至关重要。测量电池红外的方法有很多，即有很多标准。本文将介绍 IEC 61960 标准以及如何使用 Arbin 设备实施该标准。IEC 61960 电池红外标准：在该标准中，0.2C 的放电脉冲持续 10 [...] 秒。
阅读更多
Integrated Electrochemical Impedance Spectroscopy (EIS) With Arbin Charge/Discharge Channels
Introduction Electrochemical Impedance Spectroscopy (EIS) is a foundational diagnostic technique for evaluating battery health, internal resistance, degradation mechanisms, and electrochemical behavior over time. However, EIS is traditionally limited by hardware complexity and high per-channel cost, making it difficult to scale across large battery test systems. To address these challenges, Arbin Instruments offers an integrated EIS […]
阅读更多
根据实际容量恒定 C 速率，而不是使用 Arbin 循环器恒定电流
众所周知，电池的容量会随着充放电循环的进行而下降。如果我们将充放电电流设定为一个固定值，如 1A、2A......，则每次循环的时间会逐渐缩短，原因很简单，因为电池的容量在减少：循环时间 = （充电容量 + 放电容量）/电流 有时用户希望 [...]
阅读更多
在一个环境温控箱中同步不同电池的充放电通道
MTCI 简介 Arbin 的 MTCI（多温室接口）模块可与第三方环境模拟室进行无缝和复杂的集成，从而可在 Arbin 测试计划内直接控制温度和湿度设定点。这种简化的设置使测试工程师能够在编程和调整电气循环参数的同时编程和调整环境条件，从而无需单独的试验室控制系统。 [...]
阅读更多